EBSO logo

Preforming axial components


Ebsomat E40-2 / E 40-3
Trimmer/former for axially taped components

Output motor: ±70.000 cph / Output manual: ±40.000 cph
Dimension: 240 x 165 x 210 mm
Weight: 9 kg
Construction: cast aluminium housing, tooling is heat treated and tempered tool steel


Ebsomat C 043
Axial Trimmer / Former
For leads up to 1,3 mm diameter

With the new cutting and bending machine you have the possibility to work axial lying as well as axial standing components. With only a few grips, less than five minutes time, the machine can be retrofited from one component variant to another.

• easy tape insertion
• stress relief tooling prevents components damage
• pitches and lenght of the connecting wires can be adjusted gradually
• over-bending of the components is possible


Ebsomat E 400
Axial Trimmer / Former
For leads up to 1,3 mm diameter

Manual-Model
This new progressive and universal to use machine is suited for the processing of axial components. Through manual operation it is possible to read a production-speed of circa 10.000 components per hour

Motor-Drive
For treating even more components the EBSOMAT 400 can be fitted with a motor-drive. Therewith you are able to increase the capacity on 14.000 compon­ents per hour.

No mechanical stress of components due to interchangeable cutting, bending and forming
Gradual adjusting of the cutting units realizes an „overbending“ of the wire-components by more than 90° respectly 180°
The bending components are supplied with a special roller design, so that the components can not be damaged by overbending
Pitches and length of the connecting wires can be adjusted gradually
Already the standard tooling allows the processing of the components either in horizontal or vertical mode
Gradual adjusting of speed